Nipper H476

The Herbitas H476 nail clippers, 11.5cm with flat cut are made of stainless steel.

The flat cutting jaw features a straight cutting edge perpendicular to the nail surface and is used for cutting nails straight.

ALICATES USAGE INDICATIONS:

• Cutting nails and cuticles.
• Manicure and pedicure product.
• Reusable. Allows sterilization.

TECHNICAL FEATURES:

BRAND: Herbitas

MATERIAL: Stainless steel

STERILIZABLE: Sterilizable product. Reuse allowed.

WEIGHT: 20g

MEASURES: Total length of 11.5 cm ± 0.5 cm

JAW LENGTH: Total length of 15 mm

JAW WIDTH: Open width: 7.75 mm ± 0.5 mm | Closed width: 6 mm ± 0.5 mm

TYPE OF TIP: Flat cut

SPRING TYPE: Foldable single plate

STOCKAGE:

STORAGE:

• Store at room temperature in a dry place.
• Protect from heat, intense light, and dust.

WARNINGS:

• Professional use.
• The instrument must be cleaned, disinfected, and sterilized by the clinician before first use and after each use.
• Check for proper functioning and perfect condition before using the product.

CLEANING AND CARE:

Initial Recommendations:

• Perform a visual and mechanical check of the new surgical instruments.
• Visible dirt should be removed as soon as possible to prevent residues from drying.
• Avoid long waiting times for cleaning and disinfecting the instruments.

Preliminary manual cleaning:

• Initially, it must be hand washed with mild soap.
• In the operating room, the most apparent dirt must be removed as soon as possible to avoid encrustation that can lead to corrosion.
• Long waiting times for reprocessing should be avoided (<1h).
• Dry cleaning is preferable as medical devices can corrode if immersed for a long time in solutions.
• If the dry process is insufficient, it will be necessary to wash them with cold water (<40ºC), including the cavities, grooves, and difficult-to-access holes that must be washed with pressurized water. Avoid leaving unwashed areas. You can use a soft plastic brush.
• Dry thoroughly with an absorbent cloth that leaves no residue or with compressed air.

Cleaning and disinfection:

• Immerse the products in a solution of distilled water with an appropriate disinfectant in an ultrasonic bath or tank.
• Follow the instructions provided by the manufacturer of the disinfectant product to select the washing program, temperature, and time.
• Clean instruments with movable joints in the open position or move the joints to avoid "shadow areas". Follow the manufacturer's instructions for disassembling removable instruments.
• The instruments must be placed with minimal separation in the cleaning container and avoid overlapping them to prevent damage from collisions.
• At the end of the disinfection program, wash the products thoroughly with plenty of cold distilled water, insisting thoroughly on the cavities, grooves, and difficult-to-access holes of the instrument, if possible with pressurized water.
• Dry thoroughly with an absorbent cloth that leaves no residue or with compressed air.

Lubrication:

• Use Sterilit Instrumental Protector (ref. 13.859.1 and 13.859.2) to protect the instruments.
• Attach the white plastic tube provided with the spray and apply the aerosol oil directly to the joint area or hard-to-reach areas.
• Open and close the instrument several times to evenly distribute the oil and remove excess oil with a lint-free cloth. Subsequently, proceed to sterilize the instruments as the oil film is permeable to steam. It will act as a lubricant and anticorrosive without leaving stains on the instruments.

Sterilization:

• Sterilization of products taking into account the corresponding national requirements.
• Product sterilization must be carried out in a suitable sterilization container.